Serving the Jackson area  ·  (601) 213-0169  ·  Open Mon-Sun 7am-7pm
📞 (601) 213-0169 Free Quote

Metal Roofing in Pelahatchie, MS (39145) · Local Professionals

Jackson Metal Roofing · Fast response in Pelahatchie and the Jackson area · Free estimate 24h

✅ Licensed Contractor 🛡️ Licensed & Insured 💸 Free Quote 24h 🕐 Mon-Sun 7am-7pm
+352Verified Reviews
10Years in Business
4.9 ★Google Rating
24/7Available
✅ No hidden fees💳 Cards accepted🛡️ Licensed & Insured

Pelahatchie is a small town where the pines are tall, the lots are big, and most roofs are working hard under a steady rain of needles and oak leaves. The housing stock here runs from older ranch homes and farmhouses on generous acreage to newer brick builds tucked off Highway 80 and near Pelahatchie Shore Park, and just about every one of them deals with the same mix of humidity, summer storms, and debris that settles into roof valleys.

Homeowners in 39145 call Jackson Metal Roofing because we know what pine straw and shade do to a roof. We have replaced rusted-through panels on barns, repaired leaks where needles packed up behind a chimney, and installed standing seam on homes that had been re-shingled twice already. We are based in Jackson, fully insured, and we treat Pelahatchie like the close neighbor it is.

Metal Roofing in Pelahatchie (39145)

Pelahatchie sits in the Pearl River valley on that rolling Yazoo clay, so drainage and grade matter here. A lot of properties have long driveways and mature trees, which means roof access can be tight and gutters fill fast with pine needles and oak tassels. The older homes often have low-slope porches and additions where water pools if flashing is not detailed right. Farm and shop buildings on the edges of town have corrugated panels that take a beating from sun and storm, and we see plenty of fastener back-out and seam separation on those. We also run into the occasional ice dam at the eaves on the higher-elevation homes when we get that rare winter storm.

Our team has worked across Rankin and Hinds counties for years, from the small streets near Pelahatchie Attendance Center to the rural lots out toward the reservoir. We know the local building department has its own permit thresholds and inspection timing, and we pull the right permits before we start. We also know which panel profiles and colors fit the look of a small-town neighborhood, so your metal roof does not stick out for the wrong reasons.

Our services in Pelahatchie

How a Job Works in Pelahatchie

Step 1: You call (601) 213-0169 or send a message, and we set up a free on-site assessment. We walk the roof, check the attic if you have one, look at the gutters and flashing, and talk through what you are seeing. You get a written estimate with options, not a sales pitch.

Step 2: Once you approve, we schedule the work and handle the permit with the local building department. On tighter lots or where trees crowd the driveway, we plan where the dumpster and material truck go so we do not tear up your yard. If your neighborhood has an HOA or you are near a historic district, we help you get the color and profile approved before we order panels.

Step 3: We clean up every day and do a final walkthrough with you when the job is done. We haul off old shingles, sweep the driveway with a magnet for nails, and make sure your gutters are clear. You get a written warranty and our contact info for anything that comes up later.

Pricing in Pelahatchie depends on the size and pitch of your roof, how many layers are already there, and how easy it is to get materials to the house. As a ballpark, metal roof installation starts around $8 per square foot, standing seam starts around $10, metal roof replacement starts around $9, and a retrofit over existing shingles starts around $7. Smaller jobs like leak repair start around $450, screw replacement and re-fastening starts around $750, and gutters for metal roofs start around $9 per linear foot. We give free estimates and explain exactly what drives the number so there are no surprises. Call (601) 213-0169 to set one up.

My house is surrounded by pines near Pelahatchie Shore Park and needles collect in the roof valleys. Will a metal roof make that worse or better?
Metal roofs actually shed pine needles better than shingles because the surface is smooth and there are no granules to catch debris. That said, valleys and behind chimneys still collect needles, so we recommend gutter guards and a yearly blow-off. We can also design the flashing and valley metal to keep debris from packing in as fast.
A storm just peeled back some panels on my barn off Highway 80. How fast can you get out to Pelahatchie?
We prioritize active leaks and storm damage. Call (601) 213-0169 and we will schedule a free inspection, usually within a day or two depending on the weather. We can tarp or secure the area temporarily if needed and give you a written repair estimate on the spot.
What does a typical metal roof replacement cost for a 1,500 square foot ranch house in Pelahatchie?
For a simple gable ranch that size, replacement typically starts around $9 per square foot, so you are looking at roughly $13,500 and up depending on pitch, access, and whether we remove one or two layers of old shingles. We give you an exact number after a free on-site measure.
Do I need a permit from the town of Pelahatchie to replace my roof, and who handles it?
Most full replacements and re-roofs in Pelahatchie require a permit, and the threshold and inspection process are set by the local building department. We pull the permit for you and schedule the inspections, so you do not have to chase it down. Rules can change, so we always confirm with the town before we order materials.
My neighbor's oak tree drops limbs on my roof and we are not sure where the property line is. Can you help with that?
We can show you where the roof damage is and document it for your insurance or for a conversation with your neighbor, but we do not survey property lines. If your HOA has rules about roof color or panel style, we can coordinate the approval before we start so there are no issues later.
Are you insured for roof work on my Pelahatchie property?
Yes, we are fully insured with general liability and workers' compensation coverage.
What maintenance should I do on a metal roof in Pelahatchie to prevent leaks?
Keep the roof and gutters clear of pine needles and leaves, especially in fall and after storms. Check the fasteners and seals once a year, and look at the flashing around chimneys and skylights. We offer free inspections and can replace worn screws or reseal seams before they turn into leaks.
Why choose us?

Trusted professionals in Jackson

🏅

Licensed contractors

Continuous training, professional equipment, meticulous and code-compliant work

🛡️

Licensed & Insured

Full coverage on all our job sites, no exceptions

⚡

Available Mon-Sun 7am-7pm

Emergencies, weekends, holidays: available when you need us

💰

100% Free Quote

Response within 24h, no commitment, by phone or form

Our services

Our Metal Roofing Services in Jackson

All your work handled by qualified professionals in Jackson

Metal Roof Installation

Complete metal roof systems engineered for your local climate and built to outlast three shingle roofs.

Included in your service

  • Deck inspection and repair before any panel goes on
  • High-temp synthetic underlayment and correct ridge and soffit ventilation
  • Manufacturer-certified panel, trim, and flashing details for the full warranty
  • Free on-site assessment and written estimate within 24h
Learn more→

Standing Seam Metal Roofing

Concealed-fastener standing seam: no exposed screws to loosen, leak, or need re-torquing.

Included in your service

  • Panels roll-formed to the exact length of your roof, no end laps
  • Mechanically seamed or snap-lock profiles with concealed clips
  • Floating clip system that lets panels expand and contract freely
  • Kynar 500 / PVDF finish in the full architectural color range
Learn more→

Metal Roof Replacement

Full tear-off of an end-of-life shingle, cedar, or metal roof, replaced with a complete new system.

Included in your service

  • Tear-off and haul-away of the old roofing, dumpster included
  • Decking inspected board by board, rot and soft spots replaced
  • New underlayment, drip edge, valleys, and penetration flashing throughout
  • Documentation of the finished system for your insurer or future buyer
Learn more→

Metal Roof Over Shingles (Retrofit)

Retrofit metal installed over sound existing shingles: no tear-off, less waste, lower cost.

Included in your service

  • Honest deck and shingle assessment first, recover only when it is the right call
  • Furring strips or slip sheet as the panel profile and local code require
  • Existing vents, pipe boots, and flashings reworked to the new roof plane
  • Straight guidance on when tear-off is the better long-term choice
Learn more→

Metal Roof Repair

Targeted repair of damaged, loose, or storm-hit metal roofing before it reaches your ceiling.

Included in your service

  • Bent, dented, or punctured panels replaced and color-matched
  • Seams, laps, and penetrations resealed with compatible butyl and sealant
  • Failed pipe boots, closures, and ridge cap fasteners renewed
  • Written findings with photos of what we found and what we fixed
Learn more→

Metal Roof Leak Repair

Priority leak response: we trace the leak to its real source instead of caulking the symptom.

Included in your service

  • Water testing and interior tracing to find the true entry point
  • Backed-out fasteners, separated seams, and flashing gaps corrected at the cause
  • Emergency tarping available same day after a storm
  • Attic and insulation moisture check so hidden damage does not sit and spread
Learn more→

Screw Replacement & Re-Fastening

The top cause of leaks on 15 to 30 year old screw-down roofs, fixed for a fraction of replacement.

Included in your service

  • Every fastener replaced with oversized screws and new EPDM sealing washers
  • Dried-out washers and stripped holes addressed panel by panel
  • Ridge, eave, and sidewall closures renewed at the same time
  • Restores a watertight roof without replacing sound panels
Learn more→

Corrugated & Ribbed Panel Roofing

Corrugated, tuff-rib, and 5V panel roofing: the budget-friendly workhorse for homes and outbuildings.

Included in your service

  • Galvalume and painted steel panels cut to length on site
  • Correct screw pattern and torque so washers seat without over-driving
  • Foam and metal closures at ridge, eave, and rake to keep weather and pests out
  • Full color range for homes, cabins, barns, and workshops
Learn more→

Metal Shingle Roofing

The look of architectural shingle, slate, or shake with the lifespan and wind rating of steel.

Included in your service

  • Interlocking stamped steel or aluminum shingle panels
  • Walkable finished surface, easier to service than a standing seam field
  • Lightweight enough for retrofit over an existing roof structure
  • Profiles and colors that suit historic and HOA-governed neighborhoods
Learn more→

Stone-Coated Steel Roofing

Steel strength under a textured stone finish, with strong hail and wind performance.

Included in your service

  • Acrylic-bonded stone granule surface over structural steel
  • Battened or direct-to-deck installation depending on the profile
  • Class A fire rating and high impact resistance ratings
  • Tile, shake, and shingle textures for suburban and coastal homes alike
Learn more→

Copper & Specialty Metal Roofing

Copper, zinc, and aluminum for porches, bay windows, dormers, and full architectural roofs.

Included in your service

  • In-house fabrication of pans, valleys, and custom curved details
  • Soldered seams and joints where the detail calls for it
  • Isolation of dissimilar metals to prevent galvanic corrosion
  • A living patina that develops over decades of service
Learn more→

Metal Roof Coating & Painting

Restoration for faded, chalking, or surface-rusted metal, adding 10 to 15 years without replacement.

Included in your service

  • Wash, degrease, and mechanical prep of the entire panel surface
  • Rust treatment and primer on affected areas before topcoat
  • High-performance elastomeric or silicone coating system applied to spec
  • Honest assessment first: we say so when the roof is past coating
Learn more→

Flashing, Chimney & Skylight Repair

Flashing is the number one leak point on any metal roof, and it is what we fabricate best.

Included in your service

  • Custom bent step, counter, and apron flashing made in-house
  • Chimney crickets to shed water on the uphill side
  • Skylight curbs and head flashing rebuilt to the panel profile
  • Valley and wall transition details closed with matching trim
Learn more→

Snow Guards & Ice Protection

Snow retention that stops rooftop avalanches onto decks, gutters, walkways, and entryways.

Included in your service

  • Pad-style guards or continuous rail systems matched to your panel
  • Layout calculated from roof pitch, panel length, and local snow load
  • Clamp-on mounting on standing seam, no panel penetrations
  • Ice dam and eave detailing for higher-elevation homes
Learn more→

Storm & Wind Damage Repair

Wind, hail, and fallen-limb repair with thorough documentation and a straight repair-or-replace answer.

Included in your service

  • Free post-storm inspection with dated photo documentation
  • Emergency tarping and temporary weatherproofing when needed
  • A written report you can use when documenting your insurance claim
  • Honest assessment of repair versus replacement, with no pressure either way
Learn more→

Metal Roof Inspection

A written, no-obligation assessment of fastener condition, seams, flashing, and remaining service life.

Included in your service

  • Fastener, washer, and seam condition checked across the field
  • Flashing, penetrations, and closures inspected point by point
  • Coating wear, chalking, and corrosion graded panel by panel
  • Written report with photos and a straight answer on years remaining
Learn more→

Gutters for Metal Roofs

Gutters sized and hung correctly for metal roofing, where standard hangers and spacing do not work.

Included in your service

  • Seamless aluminum or half-round systems formed on site
  • Hanger placement and spacing matched to the panel profile
  • Oversized capacity and downspouts sized for heavy regional rainfall
  • Bracket spacing tightened for high-wind zones so storms do not tear the gutter off
Learn more→

Commercial & Agricultural Metal Roofing

Barns, workshops, churches, and light commercial metal roofing across the county.

Included in your service

  • Long-run panels for wide spans and low-slope structures
  • Purlin and framing attachment detailed for the building type
  • Insulation, vapor barrier, and condensation control options
  • Repairs and re-fastening for aging agricultural metal buildings
Learn more→
Verified client reviews

352+ Verified Client Reviews in Jackson

⭐⭐⭐⭐⭐ 4.9/5 · 352 verified Google reviews

Free Quote

Get Your Free Quote

Metal Roofing in Jackson · Response within 24h · No commitment · ☎ (601) 213-0169

Your Free Quote Request

Confidential · Response within 24h

✅ Free personalized estimate ⚡ Response within 24h 🛡️ Licensed & Insured 📍 On-site visits included in Jackson ✅ No hidden fees 🕐 Available Mon-Sun 7am-7pm